[nycbug-talk] HP DL165G5 Issues

[Mark Saad]

Bill
 The latest firmware did not help, I tried that last week. Maybe they have newer firmware out there.

--
Mark Saad
mark.saad at ymail.com



----- Original Message ----
> From: "billtotman at billtotman.com" <billtotman at billtotman.com>
> To: mark.saad at ymail.com; nycbug talk <talk at lists.nycbug.org>
> Sent: Thu, April 1, 2010 11:03:23 AM
> Subject: Re: [nycbug-talk] HP DL165G5 Issues
> 
> If you do have support, the 1st thing they'll ask is whether your firmware is up 
> to date.

So, check that out.

-bt
------Original 
> Message------
From: Mark Saad
Sender: 
> ymailto="mailto:talk-bounces at lists.nycbug.org" 
> href="mailto:talk-bounces at lists.nycbug.org">talk-bounces at lists.nycbug.org
To: 
> nycbug talk
ReplyTo: 
> href="mailto:mark.saad at ymail.com">mark.saad at ymail.com
Subject: 
> [nycbug-talk] HP DL165G5 Issues
Sent: Apr 1, 2010 10:31

Hello 
> Talk
  Any one out there using Hp DL165G5 servers. I have a about 10 now 
> and a number of the exhibit an odd issue. With freebsd , under i/o load the 
> system hangs for 6 to 10 seconds every 30 seconds or so , and  processes 
> are stuck in state getblk or biord . I was thinking it could be a disk or sata 
> controller issue so I swapped them both out sata for a p400 sas card and swapped 
> drives a few times sas,sata mdl dual port single port  and no change 
> .   So. Installed 8.0 7.2 7.3 all have the same issue. I then tried CentOS 
> 5.1 and 5.4 and  similar issues popped up. Formatting a 1T drive took over 
> 45min .  Any one have any ideas on what's toast ?  What would a 
> process stuck in getblk or biord refer to ? 
Mark Saad | 
> ymailto="mailto:mark.saad at ymail.com" 
> href="mailto:mark.saad at ymail.com">mark.saad at ymail.com 
> 

_______________________________________________
talk mailing 
> list

> href="mailto:talk at lists.nycbug.org">talk at lists.nycbug.org

> href="http://lists.nycbug.org/mailman/listinfo/talk
> " target=_blank >http://lists.nycbug.org/mailman/listinfo/talk
> 


Sent via BlackBerry